Distance changes the design.
Base metals operations around Mount Isa reach far into country where the nearest technician can be hours away. That has a direct effect on the system. Equipment must be reliable, easy to diagnose from a distance and simple to swap when something fails.
We standardise hardware across sites, specify spares that can be held locally, and build in remote health monitoring so faults are known before a trip is booked. Heat is extreme in summer, so enclosures, cabinets and power supplies are rated and ventilated for it.
Designing for the North West
- Standard hardware across all sites
- Local spares holding recommended
- Remote health and fault monitoring
- Heat-rated cabinets and power
- Lightning and surge protection
Camps, workshops and outstations.
In town, the work tends to be accommodation, workshops and industrial yards. Further out, it is outstation camps, laydown areas and access roads, often off-grid. Wireless point-to-point and solar towers connect these back to a central VMS that managers can view from anywhere.
Access control runs off roster data, so FIFO and DIDO crews are active only for their swing. We install and service across Queensland, and supply equipment Australia-wide.
Typical scope
- Village access per swing
- Workshop and yard CCTV
- Solar towers at outstations
- Wireless backhaul between sites
Common questions.
Do you travel to Mount Isa for service?
Yes. We plan service visits around your rosters and group work so each trip covers as much as possible.
How do you handle failures so far from town?
We design for remote diagnosis and recommend a small local spares holding so a part can be swapped quickly.
Will equipment cope with North West summers?
We specify heat-rated cameras, ventilated cabinets and protected power supplies for the conditions.